http://www.qdev.de/?location=qbox/ppqbox


The ppQBox mainboard
1999-03-21

On Saturday, 1999-03-13, I finished the ppQBox mainboard. Now (1999-03-21) I have the needed time to update the QBox section to show you the results. The name "ppQBox" (pre_pre_QBox) I have choosen, because I think I will need two further generations of mainboards before I'm able to create the "all-killing super-machine" ;) - the real QBox...


1. Images of the board

1.1 Top side view
ppQBox mainboard top view This is the top-view of the ppQBox mainboard. Isn't it a nice board?!? ;)
Well, as you can see, the ppQBox consists of three boards: the mainboard, the SRAM board and of the CPU board. If I get the chance to produce multi-layer boards, it will be of course only one board but I unfortunately have no chance to do so.... :(



1.2 Bottom side view
ppQBox mainboard bottom view Hehehe... and this is the bottom-view of the board... crazy, isn't it? ;) Hmm... I used the incredible amount of 100 m vero wire... well, and I had much luck: I made no mistake and the board worked immediately!!!



2. Functional areas of the ppQBox mainboard
ppQBox mainboard areas


3. Discussion / Explanation
The ppQBox mainboard is more or less a standard ColdFire design, I have not much own logic on it. But this is not really important, the most important step was and is to have a own mainboard, no more Motorola developer board. The reason for this is, that this way I have the complete control/knowledge for/about this CPU also from hardware point of view. The Motorola developer board is great to make first steps with the ColdFire architecture because all works fine immediately. But if you want (like me) to build your own computer system, you should not rely on ready-to-use example designs...

The main advantage of my mainboard design is the GoldCap buffered SRAM. This option gives me the chance to have the systems BIOS in a memory which doesn't need to have it's own programming algorithms like FlashROM, because my memory is a simple SRAM which holds it's data in the power-off mode by buffering the supply voltage with a 1 F GoldCap.

The two expansion slots mounted on the mainboard are connected to all signals of the address-bus, data-bus and to all further control lines of the ColdFire/Board. Because of this, the two slots allows me to add almost anything two the board.

On power-on the following happens:

You now may ask: "How do you get the code (BIOS) into the unprogrammed board??" -- Well, that's really easy: I use the BDM-Debug Interface-Cable connected to my PC where I can change everything I need for a initial setup. This setup is only needed once because all of the next power-on's are fully controlled (without needing a PC!!) from the BIOS located in the GoldCap-buffered SRAM... ;)


Hmm... that's all for now.
Any comments/questions? Just write a mail to me... :)
This is the print version.
Back to normal view